IEC 60695-2-11 Fire hazard testing – Part 2-1 1 : Glowing/hot-wire based test methods – Glow-wire flammability test method for end-products

1 Scope

This part of IEC 60695 specifies the details of the glow-wire test to be applied to end-products for fire hazard testing.
For the purpose of this standard, end-product means electrotechnical equipment, its subassemblies, and components.
One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications.

2 Normative references

The following normative documents contain provisions which, through reference in this text, constitute provisions of this pari of IEC 60695. For dated references, subsequent amendments
to, or revisions of, any of these publications do not apply. However, parties to agreements based on this part of IEC 60695 are encouraged to investigate the possibility of applying the
most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies. Members of IEC and IS0 maintain
registers of currently valid International Standards.

IEC 60695-2-2:1991, fire hazard testing – Part 2: Test methods – Section 2: Needle-flame test
IEC 60695-2-1 0:2000, Fire hazard testing – Part 2-10: G/owing/hot-wire based test methods – Glow-wire apparatus and common test procedure
ISO/IEC 13943:2000, fire safety – Vocabulary